Open now  Mon-Fri 9-5   Sat 10-3   Sun closed  ยท  24/7 towing (416) 661-6665  ยท  [email protected]

Ball Joint Replacement

Tight steering and safe handling start here.

Service detail

Tight steering and safe handling start here.

Ball joints are the pivot points that connect your wheels to the suspension, letting the wheels steer and move up and down at the same time. They carry the weight of the car, so when they wear out you get looseness in the steering and, in extreme cases, a wheel that can separate.

We replace worn ball joints with quality parts, torque every fastener to manufacturer spec, and road test to confirm tight, quiet steering. If the control arm bushings are worn too, we will show you and let you decide.

Ball Joint Replacement being performed at Apex Collision Center

Serving North York and the GTA

Drivers from across Toronto, Mississauga, Scarborough, Etobicoke, Vaughan and Markham trust Apex for ball joint replacement. Our shop is at Unit 41 & 42, 4544 Dufferin Street, Toronto, ON M3H 5X2, right off Highway 401.

Warning signs

How to tell you need it

  • Clunking or knocking over bumps, especially when turning
  • Steering feels loose or wanders on the highway
  • Uneven or feathered tire wear on the front tires
  • Vibration in the steering wheel
  • A technician notes play in the joint during inspection
Noticing any of these? Book an inspection and we will confirm what is going on before you spend a dollar on repairs.
Our process

How we do it

Lift and load test

With the car on the lift we check each joint for vertical and lateral play under load, the only reliable test.

Replace the joint

The worn joint is pressed or unbolted out and a new quality joint is installed, or the full control arm if that is the better repair.

Torque to spec

Every fastener is torqued to manufacturer specification with suspension loaded where required.

Road test

We road test over bumps and through turns to confirm the clunk is gone and steering is tight.

The fine print, up front

What is included, how long it takes, how we price it

What is included

  • Suspension inspection to confirm the ball joint is the true cause of the noise
  • Quality ball joint or complete control arm assembly as appropriate
  • Proper torque specs on every fastener
  • Related bushings and hardware inspected while apart
  • Wheel alignment check recommended and quoted separately
  • Road test over bumps and through turns to verify the fix

How long it takes

Usually 2 to 3 hours per side. Control arm assemblies can be quicker than pressing in individual joints.

How pricing works

Quoted per side with parts and labour separate. If an alignment is needed after the work, it is quoted as its own line so you see the full picture.

Straight answers

Ball Joint Replacement questions

A slightly worn joint should be replaced soon. A badly worn or separating joint is dangerous and can let the wheel fold under the car. If you hear loud clunking, get it checked right away.

Not always, but joints wear at similar rates. We inspect both sides and recommend based on actual play, not guesswork.

Ball joint replacement can change alignment angles, so we recommend a check afterward to protect your tires.

Keep exploring

Related services

Fuel Pump Replacement service at Apex Collision Center

Fuel Pump Replacement

Fuel pump diagnosis and replacement with fuel pressure testing before and after the job.

Learn more →
AC Service and Replacement service at Apex Collision Center

AC Service and Replacement

AC recharge, leak detection, compressor and component replacement with proper evacuation and testing.

Learn more →
Wheel Bearings Replacement service at Apex Collision Center

Wheel Bearings Replacement

Wheel hub and bearing replacement that eliminates humming, grinding and play at the wheel.

Learn more →

Your car deserves the Apex treatment

Call, email or book online. We will diagnose the issue, give you an upfront price, and get you back on the road with work done right the first time.

Call (416) 661-6665