Open now  Mon-Fri 9-5   Sat 10-3   Sun closed  ยท  24/7 towing (416) 661-6665  ยท  [email protected]

CV Axle and Shaft Assembly Replacement

End the clicking and get power to the wheels.

Service detail

End the clicking and get power to the wheels.

CV axles deliver engine power to your front wheels while letting them steer and move with the suspension. Their joints are packed in grease under rubber boots. When a boot tears, grease flies out, dirt gets in, and the joint starts clicking on turns.

We replace the complete axle assembly with a quality unit, which is more reliable than rebooting a joint that has already run dry. New axle nuts are torqued to spec and the car is road tested through full lock turns.

CV Axle and Shaft Assembly Replacement being performed at Apex Collision Center

Serving North York and the GTA

Drivers from across Toronto, Mississauga, Scarborough, Etobicoke, Vaughan and Markham trust Apex for cv axle and shaft assembly replacement. Our shop is at Unit 41 & 42, 4544 Dufferin Street, Toronto, ON M3H 5X2, right off Highway 401.

Warning signs

How to tell you need it

  • Clicking or popping when turning sharply
  • Grease splattered on the inside of the wheel or under the car
  • Vibration under acceleration that smooths out when coasting
  • Clunk when shifting into drive or reverse
  • Torn or cracked CV boot spotted during inspection
Noticing any of these? Book an inspection and we will confirm what is going on before you spend a dollar on repairs.
Our process

How we do it

Confirm the axle

Full lock turns and on lift inspection confirm the clicking axle and check boot condition on both sides.

Replace the assembly

The complete axle is replaced with a quality unit, including new axle nut and fresh transmission seal where applicable.

Torque to spec

The axle nut is torqued to the exact manufacturer specification, critical for bearing and joint life.

Road test

Figure eights and highway runs confirm no clicking, no vibration and no leaks.

The fine print, up front

What is included, how long it takes, how we price it

What is included

  • Road test and turn test to confirm which axle is clicking
  • Boot inspection for tears and grease loss
  • Quality complete CV axle assembly
  • Transmission seal inspection while the axle is out
  • Proper torque on the axle nut and suspension fasteners
  • Road test with sharp turns to verify the clicking is gone

How long it takes

Usually 1.5 to 2.5 hours per side.

How pricing works

Quoted per side with parts and labour separate. We replace the complete assembly rather than rebooting a worn joint, because it lasts longer and costs less in labour.

Straight answers

CV Axle and Shaft Assembly Replacement questions

If caught immediately before dirt enters, sometimes. Once the joint has clicked or run dry, the damage is done and a complete axle is the reliable fix.

It is a countdown. The joint can last weeks or months after the boot tears, but once it starts clicking, replacement is the only fix. Earlier is cheaper.

Only the failed one, but we inspect both boots at every visit so the other side never surprises you.

Keep exploring

Related services

Ignition Coils and Spark Plugs Replacement service at Apex Collision Center

Ignition Coils and Spark Plugs Replacement

Spark plug and ignition coil service that cures misfires, rough idle and hesitation.

Learn more →
Engine and Transmission Mount Replacement service at Apex Collision Center

Engine and Transmission Mount Replacement

Motor and transmission mount replacement that eliminates clunks, vibration and harsh shifting feel.

Learn more →
Collision Body Work service at Apex Collision Center

Collision Body Work

Collision body repair: dent removal, panel replacement and alignment that bring your car back to factory lines.

Learn more →

Your car deserves the Apex treatment

Call, email or book online. We will diagnose the issue, give you an upfront price, and get you back on the road with work done right the first time.

Call (416) 661-6665