Open now  Mon-Fri 9-5   Sat 10-3   Sun closed  ยท  24/7 towing (416) 661-6665  ยท  [email protected]

Oxygen Sensor Replacement

Fix the check engine light and get your mileage back.

Service detail

Fix the check engine light and get your mileage back.

Oxygen sensors tell your engine computer how to mix fuel and air. When a sensor gets slow or fails, the computer guesses, which means worse fuel economy, rough running, failed emissions tests and a check engine light that will not stay off.

We verify the sensor is truly the fault with live data, because wiring and exhaust leaks can set the same codes. The new sensor is installed with anti seize, torqued correctly, and the system is confirmed in closed loop on a road test.

Oxygen Sensor Replacement being performed at Apex Collision Center

Serving North York and the GTA

Drivers from across Toronto, Mississauga, Scarborough, Etobicoke, Vaughan and Markham trust Apex for oxygen sensor replacement. Our shop is at Unit 41 & 42, 4544 Dufferin Street, Toronto, ON M3H 5X2, right off Highway 401.

Warning signs

How to tell you need it

  • Check engine light with an O2 sensor code
  • Fuel economy drops noticeably
  • Rough idle or hesitation
  • Rotten egg smell from the exhaust
  • Failed Drive Clean or emissions test
Noticing any of these? Book an inspection and we will confirm what is going on before you spend a dollar on repairs.
Our process

How we do it

Confirm with live data

We watch sensor waveforms and fuel trims to prove the sensor is slow or dead, not a wiring or exhaust leak issue.

Replace the sensor

The failed sensor is removed with the proper socket and a new quality sensor is installed to the correct torque.

Check the circuit

Heater circuit, wiring and connectors are tested so the new sensor is not condemned by a bad wire.

Verify operation

Codes are cleared and a road test confirms fuel trims return to normal and the light stays off.

The fine print, up front

What is included, how long it takes, how we price it

What is included

  • Scan and live data to confirm the sensor is the cause, not a symptom
  • Exhaust and wiring inspection for the real root cause
  • Quality oxygen sensor matched to your vehicle
  • Proper torque and anti seize on the threads
  • Code clear and drive cycle verification
  • Fuel trim readings rechecked to confirm the fix

How long it takes

Usually 1 to 1.5 hours. Sensors seized in the exhaust can take longer, and we will tell you if that happens.

How pricing works

We verify the sensor is actually failed before replacing it, because O2 codes are often caused by exhaust leaks or fuel issues. You pay for the fix, not a guess.

Straight answers

Oxygen Sensor Replacement questions

Short term, yes, but fuel economy suffers and a rich mixture can overheat and destroy the catalytic converter, which costs far more than a sensor.

Clearing the code does not fix the sensor. The computer will set it again, usually within a few drive cycles, and the underlying problem continues.

We test both. Upstream sensors control fuel mixture, downstream sensors monitor the converter. The data tells us which one failed.

Keep exploring

Related services

Battery, Alternator and Starter Check service at Apex Collision Center

Battery, Alternator and Starter Check

Complete starting and charging system testing: battery, alternator, starter, cables and parasitic drains.

Learn more →
CV Axle and Shaft Assembly Replacement service at Apex Collision Center

CV Axle and Shaft Assembly Replacement

CV axle replacement for clicking on turns, torn boots and vibration under acceleration.

Learn more →
Ignition Coils and Spark Plugs Replacement service at Apex Collision Center

Ignition Coils and Spark Plugs Replacement

Spark plug and ignition coil service that cures misfires, rough idle and hesitation.

Learn more →

Your car deserves the Apex treatment

Call, email or book online. We will diagnose the issue, give you an upfront price, and get you back on the road with work done right the first time.

Call (416) 661-6665